1. When using the electric chuck device, in order to ensure the accuracy of the device, it is important to need smooth operation, because incorrect or inappropriate smoothness will cause some problems, such as abnormal function at low pressure, weakening of clamping force, and clamping. Poor precision, abnormal wear and jam, so it is necessary to smooth the chuck properly.
2. When maintaining the equipment, it is necessary to pay attention to molybdenum disulfide grease at least once a day, and put the grease into the chuck nozzle until the grease overflows the jaw surface or the inner hole of the chuck, but if the chuck rotates high or a lot of water cutting When oil is used in processing, the demand is more smooth and must be determined according to different conditions.
3, clean it and clean it, at least every 6 months to remove the disc differentiation and cleaning, adhere to the sliding surface of the jaws clean and smooth, so that the life of the chuck increases.
However, if the cast iron is cleaned at least once every two months or repeatedly, check whether the parts are broken or worn. If it is serious, replace the new one immediately. After the end of the review, you must fully supply the oil before you can form a group.
4, the use of anti-rust effect cutting oil, can prevent the inside of the chuck rust, due to the rust of the chuck will reduce the clamping force, and can not clamp the workpiece.
5. For different workpieces, it is necessary to use different clamping methods or select special fixtures. The three-jaw chuck is only used in a general-purpose type of jig, and it is forced to use it to clip irregular or weird parts, which will cause the chuck to be damaged!
